Loading...
 

INSTALLATION INSTRUCTIONS

SMALL LIGHT INSTALLATION

TO INSTALL:
Small sized applications may be applied dry and medium to large light installations may be applied wet for best results.

First, Clean lens thoroughly. Then peel backing off of film (prevent the film from touching any foreign surfaces). Wet application: spray a very light mist of water onto lens (one or two sweeping sprays from 10-12 inchs away is sufficient). Then align and apply film to one side or center of the light or area. Then using a plastic application card, press down/sweep the remainder of the film across the light. If large bubbles are present or film is misaligned, peel up the film to that area and apply again. If film is not precut then use an X-acto knife, triangular pointed knife, or razor blade to trim off the excess film. If product is precut then remove the handling tabs.

SETTLING:
Small air bubbles and creases/ripples will disappear over time film settles and is warmed. Minor scratches will also disappear over time and after film maintenance by waxing or applying 303 vinyl conditioner.

PAINT & LARGE LIGHT INSTALLATION INSTRUCTIONS

Our paint protections include complete installation instructions, which describes the best installation method for each area/piece. Also included are labeled diagrams of kit. We are also available to verbally assist the customer if any questions or complications arise. If you do decide not to install yourself, we can attempt to locate professional installer within your general vincinity.

Right right-line