is proud to introduce its "World Challenge" Sport Lowering spring sets
for the Audi B8 platform. Designed, tested and developed with Eibach, the GMG
WC Sport Lowering Spring sets are manufacteredc to GMG's exact
specifications. Unlike most tuners who simply take an off the shelf
lowering spring and rebrand it with their name, GMG developed a
completely new design that would not only improve the handling of the
B8 chassis but would also improve the comfort and ride quality, while
maintaining maximum control.
The GMG WC lowering
springs are a progressive rate design with step-less pitch and offer
improved ride quality over stock, the factory springs are linear rate.
GMG runs a much higher rate than the factory spring as well. (Many
tuners and spring manufactures actually run lower rate than stock to
lower the vehicle which often times results in that unwanted "bouncy"
The springs are also matched to the factory dampers so you don't have a
car that is over sprung and under dampened or vise versa.
By replacing your stock suspension with the B8 or B8.5 Audi A4/S4 A5/S5 GMG Racing Lowering
Springs you can
expect a 1.2" lower stance in both the front and rear..
Successfully lower your 3 series with a proven GMG Racing suspension,
the B8 or B8.5 Audi A4/S4 A5/S5 GMG Racing Lowering Springs.
B8 or B8.5 Audi A4/S4 A5/S5 GMG Racing Lowering Springs Features
- Compatible with OEM shocks
Improved stance and appearance for your B8 or B8.5 Audi A4/S4 A5/S5
- High Tensile Steel
- Renowned GMG Racing high quality construction
- ISO9001 & TUV approved
with Active Damper Systems
- Improved handling
About Lowering Springs
lowering springs like the GMG Racing Lowering Springs are commonly used to lower the ride height and to
reduce body roll. This is also often done when upgrading to a larger
wheel and tire package to minimize unsightly wheel gap. When trying to decide which lowering springs are right for you, your goal should not be to drop down the car as far as possible. In many cases, overly
lowering your B8 or B8.5 Audi A4/S4 A5/S5 may actually be illegal for road use and cause
it to perform worse than it did stock. Ideally using springs to lower
your B8 or B8.5 Audi A4/S4 A5/S5 are best done between 1" and 2", any lower and you would be
better suited going with a coilover setup.
Approx. Front Lowering
Approx. Rear Lowering
Audi B8 A4/S4
Audi B8 A5/S5
.5-1.5" (varies by model)
.5-1.5" (varies by model)
Installation for the B8 or B8.5 Audi A4/S4
A5/S5 GMG Racing
Lowering Springs is
classified as moderate hard. You will need standard tools to disassemble your
suspension, in addition to a spring compressor. Professional installation is
highly recommended for this product.