The Diode Dynamics LED Reverse Light for
2015+ Ford Mustang
SMD27: 27 three-chip
5050-size Epistar SMDs arranged in 180 degrees. Six radial panels of
three chips, and a forward-facing six-chip panel. Main body material is
HP11: Four side-firing
1.5W-rated Osram LED chips, and one 5W-rated LED chip on top, which is
projected by a lens for maximum effective brightness. The bulb is housed
in a machined aluminum casing, which provides superior heat diffusion
for long life.
XP80: Each of the four
sides of this bulb contains three 5W-rated chips, and the top is fitted
with four more under a projector lens. This is the brightest
self-contained automotive LED bulb on the market, and is housed in an
aluminum casing with a textured finish for maximum heatsinking
Fitment. All three bulbs
use a quality inject-molded 3156 terminal, with a locking base connector
and proper pin alignment, designed for exact replacement of your factory
Included in your order is ONE
Bulb appearance may vary depending on which LED reverse bulb you choose.
BEWARE! Most sellers just provide "calculated" lumen numbers, based on
the maximum potential brightness of the LED chips on the bulb. For
example, if a bulb has five 10-lumen chips, they will rate it at 50
lumens. However, this is not accurate, as the design of an LED bulb does
not get rid of heat fast enough to run the LEDs at maximum.
These "calculated" lumen ratings are much, much higher than the true,
measured light output, so it will look like competitors' bulbs are
brighter than ours. This is because Diode Dynamics does not provide
inflated "calculated" numbers; we believe it is misleading. We test the
actual brightness of the bulbs in our lab, to provide real lumen output
measurements. Our measurements are accurate, but they are usually much
lower than the misleading "calculated" figures. Please click
here to learn more about LED brightness measurement.
Components. Diode Dynamics uses only the highest quality LED
chips in the production of its bulbs. This means we use only brand-name
suppliers such as Epistar, Cree, Osram, and Samsung.
While our bulbs may look the same as others on the market, most copycat
bulbs use economy-grade LED chips in order to reduce costs. This greatly
reduces the reliability and overall brightness of the bulb when you
compare it to Diode Dynamics.
Construction. Although LED technology allows for extremely long
bulb life, the market is flooded with cheap LED bulbs that fail
prematurely due to inferior construction. The worst enemy of LEDs is
excessive heat, and when bulbs are not designed properly, they do not
disperse heat as well, leading to premature failure.
Off-brand, cheap bulbs exhibit poor solder uniformity, high levels of
flux in the solder, uneven chip placement, low-gauge terminal wires,
poor assembly, and bulbs held together with inferior adhesives. At best,
solder joints will crack and fail on low-quality LEDs after a few weeks
of use. In the worst case, these bulbs can damage housings as the extra
flux and adhesive evaporates and creates a residue on the lens of the
Diode Dynamics bulbs are produced with modern, computerized equipment,
and only the best materials, to ensure complete uniformity, high
quality, and long bulb life.