Skip to main content

Brake Pad Wear Sensors from StopTech for 1999-2006 BMW 3-Series & M3 [E46]

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!


Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.

$15.00 - $33.99
(No reviews yet) Write a Review
SKU:
SPTCHBRKSNSRE46_PR

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!


Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.

Shipping:
$7.00 (Fixed Shipping Cost)

WARNING: product may contain chemicals known to the State of California to cause cancer, birth defects, and/or reproductive harm.
For more information, go to www.P65Warnings.ca.gov.

DISCLAIMER: Products that affect or remove vehicle emissions equipment (Intakes, Manifolds, Tuners, etc) that do not have a CARB EO number may not be available for sale in the state of California. Please contact us if you are unsure if a product is available for sale in California. ModBargains complies with all EPA and CARB regulations.

Now available are StopTech Brake Pad Wear replacement Sensors for your BMW E46 3 Series or M3. Replace your old, unusable sensors with these brand new, high quality StopTech sensors when getting your brakes done.

Why Would I Need New Sensors?
Your BMW has eight brake pads, but only two of them are actually monitored for wear (the inner driver's side front pad and inner passenger rear pad). When a pad has worn down to below 2mm or remaining frictional material, the rotor will chew through a small plastic bump on the sensor which slices the wire in half and causes your car to show a warning sign on your dash. This is usually warning you that you will need new pads soon. However, once a sensor has been used and a warning has shown, the sensor is destroyed and must be replaced with a new one.


Mod Category:
Brakes
Mod Subcategory:
Sensors