Tired of the soft, sloppy pedal feel of your E90's factory brake system? Firm
it up with StopTech's new E90 stainless steel brake lines. These brake lines
improve pedal feel and reduce the amount of time between applied pedal pressure
and actual deceleration by reducing the expansion that is allowed by stock
rubber flex lines. This provides a quicker pedal response and allows the driver
to maintain consistent brake pressure with precision brake modulation.
All necessary
brackets and fasteners are included with each line kit. Adding a set of StopTech
Stainless Steel Brake Lines to your performance vehicle will provide an
immediate improvement to brake performance and pedal feel from the very first
stop.

StopTech brake lines consist of a TeflonĀ® inner line that is covered with a
layer of stainless steel woven braid. The Teflon tube is very resistant to
expansion under pressure and will not degrade from exposure to brake fluid. The
stainless steel braid provides support for the Teflon and the weave is extremely
durable against incidental impact and abrasion. StopTech brake lines feature a
Clear Abrasion Resistant Cover for maximum protection against chaffing
All StopTech Stainless Steel Brake Lines are DOT compliant and 100%
tested to a pressure of 4500 psi.
Front: 950.34013
Rear: 950.34525
Compatibility:
-2006 E90 325 excluding xi
-2006 E90 330i excluding xi
-2007-2012 E90 328i Sedan
-2007-2012 E91 328i Sports Wagon
-2007-2012 E92 328i Coupe excluding xi
-2007-2012 E90 & E92 335i Sedan and Coupe
-2007-2012 E90/E92 335xi/xdrive (950.34024)

What our
customers say about this product:
"I recieved the Stoptech lines and ATE fluid in about a week. The quality of the
lines were top notch, along with the extra instructions that came with them. The
rubber coating is a big plus, as it definately adds to the longevity of the
lines. As far as extra performance, the lines and fluid firmed up the pedal
slightly under normal braking and quite a bit under hard braking." - Andrew M
from E46Fanatics
Disclaimer:
StopTech Stainless Steel Brake Lines are designed as direct replacement parts
for stock brake lines. The replacement lines typically follow the same routing
as the stock lines. While the design is tolerant of slight modifications to the
intended vehicle, any excessive lowering or raising of the vehicle may make the
lines unsuitable for use on that particular car, truck, or SUV. Also, the lines
include provisions for routing attachments on the stock suspension, such as
brackets on the strut. If an aftermarket suspension is on the vehicle, the stock
mounting points may not be on those components.
If alternate routing or modifications are required, it is the sole
responsibility of the installer to assure that the lines are not binding or
touching any part of the suspension or drive train. Inspect the line routing
through the entire range of suspension travel, both up and down and
left-to-right. If there is any question as to whether or not the install is
correct, do not drive the vehicle until there is absolute assurance the lines
are safely routed.