Up to 82hp to
the wheels (100hp+- crank) on a completely stock car or MORE on a fully modified car!!!
With the insane turn
out of the original N54 JB4, it was clear that BMS had to take it to a
whole new level with BMW's new S55 engine. So for all you new S55
owners out there Burger Motorsports has finally come out with the
infamous BMS S55 JB4 Tuner for the new single turbo engines that are in the
F80 M3 and F82 M4.
From the factory all of these BMW's come
very detuned, and far from its full potential. The BMS
Tuner for the S55
is a piggy back system, which means it is untraceable by scan tools, so
no need to stress about the BMS S55 Tuner voiding your warranty. The
BMS S55 Tuner is simple, it plugs into the vehicle's computer and controls the
amount of boost.
Not only giving you unheard of horsepower and
torque gains but also better throttle response and an
overall better sports car feel.
Whether your vehicle is stock or fully modified, the
Tuner will
adjust to the modification and make the most out of them. All this
and more makes the
BMS S55 Tuner the #1 software
choice for the fastest 1 series and 3 series in the world.
When it comes to choosing the best performance software for your 135i,
335i/xi, or 535i GT, only settle for the best with the
BMS S55 Tuner.
JB4 Map Guide
Map 0: Disable
JB4 / Full Pass Through Mode
Map 1: Stage1
map adding approximately 40whp and 40wtq across the power band on pump
gas. Suitable for all stages and fuel mixtures.
Map 2: Slightly
more aggressive version of map 1 intended for vehicles with exhaust
modifications and 93+ octane fuel. Can also be used with E85 and racing
fuel mixtures.
Map 3: Slightly
less aggressive version of map 1 intended for vehicles running on lower
grade fuels such as 91 octane.
Map 4: OEM
performance but with JB4 active for diagnostics only.
Map 5: //M
low torque / linear throttle map.
Map 6: Custom
tuning map.
Map 7: Race
gas map. Requires 100 octane unleaded fuel and for the fuel mass
connector to be installed. This map can also be used with up to 35% E85.
Map 8: Methanol
injection map. Requires BMS FSB controller or methanol kit for
progressive mapping and safety systems. |
